They simply slide out of their location, they have an alignment groove so their position can’t be mixed up. For the HVAC panel, pull off the rotational knobs. There will be a Phillips screw on the bottom which needs to be removed. Remove the ashtray, depress the top metal portion and pull straight out. Next is disconnecting the electrical components on the rear, for this, I have two 12v power ports and the factory security led. Push in the center of the clip, then remove, and the panel can be lifted out. This trim piece should have two push-in clips, one on each side as shown by the exposed holes. When I bought this truck, the interior was partially apart and some fasteners were missing so I’ll try to do my best to cover what’s missing. Remove the lower trim panel below the radio bezel. First is disconnecting the battery as we are working with the electrical system.
0 Comments
Leave a Reply. |